想SLI？来看看别人的测试再说

jpbird

<a href="http://www.firingsquad.com/hardware/msi_nx6800/page5.asp" target="_blank" >http://www.firingsquad.com/hardware/msi_nx6800/page5.asp</A>

jpbird

<P><a href="http://forum.lockon.ru/showthread.php?t=7635" target="_blank" >http://forum.lockon.ru/showthread.php?t=7635</A>。这里有人已经做过尝试了，结果发现：</P><P>Well then, after several restarts i finally had SLI going, but it apeared very unstable! I tryed lock on 1.1 and i could run it for about 1 min before my computer shut down. It was the same with far cry also.</P>

jpbird

<P>第22楼回复：</P>
<P>I ran tests at 1024x768,1280x1024,1600x1200, windowed and full screen with no AA/AF and 4AA/8AF. I used coolbits to allow me to set the profile for Lock-on to use SLI Mode (Nvidia sets the profile to single GPU). I was only able to use the AFR SLI mode (The SFR mode casued graphic errrors, lower half of the screen had a white look to it). There was no FPS increase, SLI mode ran just as fast as Single GPU mode, maybe at most 1 frame slower on the min FPS.

As for the Mig intercept Demo, it had the same results, no FPS improvement when in SLI mode. Here are the results from the demo

1600x1200 4AA/8AF Single GPU Avg: 15.344 - Min: 8 - Max: 22
1600x1200 4AA/8AF SLI Mode Avg: 14.952- Min: 7 - Max: 22

1600x1200 no AA/AF Single GPU Avg: 26.397 - Min: 9 - Max: 63
1600x1200 no AA/AF SLI Mode Avg: 26.162 - Min: 9 - Max: 64

If I am able to find out anything usefull about SLI mode with Lock On I will post it here. All tests where with a clean install of 1.02 with no mods.

这帖子里甚至在20楼以后有不止一个说SLI几乎没有提高。</P>

[此贴子已经被作者于2005-4-24 21:44:57编辑过]