|
My system is a 3.0Ghz AMD dual core, with a 9600 GTS nvidia card. After initial install no matter what res setting, or detail settings I used I was stuck in the high teens low to low 20's on my FPS. For some reason, I went into the Config section on the launcher and under hardware settings I turned off the shaders off, and then applied that, then without closing, I went back and applied the shaders back. When I got back in the sim my FPS went to 112!!!! All my sliders were at the minimum and quality was at zero. I bumped all my sliders back up and moved the quality back from 0 to 2. Now on 1920X1200 I am running in the high 60s. I can't explain why this worked, or why I even tried this. I have confirmed this now with two others who were having the same low FPS issue. . g; f: U! G9 m2 x- @
I was almost ready to go new computer shopping just before doing this!1 }2 \* v6 F& }' w; ]2 x1 Y
Hope this may help others with same problem.3 d' `/ o; t- w1 b6 E8 `& S! x
Oh what a great day!!!!8 [$ q1 r- I% J
2 P4 n9 S0 Y- [- X3 R
Cantoo ' k, R( y2 Q: c. t' k3 E7 n0 {4 b
" V \8 l
我是用 amd 3.0ghz 雙核加 n 卡9600 GTS 的, 安裝 bms4 後, 不管如何設置, fps 20左右, 於是我在bms啟動前按 "configuration" 之後在 falcon bms config 的 setting hardware 把 sharder 去掉, 之後表 apply changes.....之後竟然有 112fps, 由於有112的fps 我可以在游戲上的畫面設定稍為調高, 包括 multismapling 我可以由0設為2了. 現在我用1920x1200仍然有 60 fps..
|
|